Command: buffershigh

  BUFFERSHIGH tells FreeDOS how many disk buffers it should allocate.
  BUFFERSHIGH is a CONFIG.SYS / FDCONFIG.SYS command. 

Syntax:

  buffershigh=nn[,m]
    nn  is the number of primary disk buffers, in the range 1-99.
    m   is the number of secondary disk buffers, in the range 1-8.

Options:

  Usage:

  The default setting depends on the amount of conventional memory 
  your system has:

  Memory (KB)                Primary Buffers           Secondary Buffers
  ----------------------------------------------------------------------
    < 128                           3                         1
  128 - 255                         5                         1
  256 - 511                        10                         1
  512 - 640                        15                         1

Comments:

  Increasing the number of BUFFERS can improve the speed of programs 
  that work with a large number of files, but also uses up more 
  memory resources.
  The secondary buffer option is available for compatibility with
  other DOS kernels, but is ignored by the FreeDOS kernel. In MS DOS,
  a secondary buffer can used to read-ahead data. FreeDOS does not do
  this. Buffers are stored in HMA by FreeDOS, unless you select nn to
  allocate more buffers than fit in HMA. If nn is smaller, unused HMA
  space will be used for further buffers until something else allocates
  the HMA space for something else. Even then, at least nn buffers will
  always be available. You can set nn to a negative value to disable
  the use of unused HMA space: BUFFERS=-10 only uses 10 buffers, further
  free space in the HMA will just stay unused.
  BUFFERSHIGH is like BUFFERS, except it attempts to load into high 
  memory first (failing that it should load in conventional memory).
  Note: The order you load devices may have a large impact on amount
  of free memory available. In general try to load large (in memory
  usage) programs into high memory first.
  Important: You should have a high memory manager such as (HIMEM),
  HIMEMX or JEMMEX installed (prior device=himem.exe or device=himemx.exe
  in CONFIG.SYS / FDCONFIG.SYS) before using this option.
  BUFFERSHIGH is a command internal to kernel.sys and needs no other file
  in order to work.

Examples:

  IN CONFIG.SYS / FDCONFIG.SYS:
    buffershigh=3,1

See also:

  buffers
  config.sys
  fdconfig.sys
 (fdxms)
 (fdxms286)
 (himem)
  himemx
  jemmex

  Copyright © 2003 Robert Platt, updated 2011 by W. Spiegl.

  This file is derived from the FreeDOS Spec Command HOWTO.
  See the file H2Cpying for copying conditions.